廣西10KV線路油浸式計量箱現貨價格

JLS-6、10型計量箱適用于下列場合的電能計量：

a、農村排灌站，鄉鎮企業、加工廠、中小型工廠、礦區、交通運輸?shù)雀鞣N企、事

 業單位以及林業、基建工地暫設供電站的高壓輸電線路的電能計量。

b、小電站發電量計量或小電站電網與國家進行聯網運行時互送電能時的計量。

2、使用環境條件：

2.1海拔高度不超過1000m；  

2.2環境溫度：

高＋40℃；

日平均不超過30℃；

低-25℃；

2.3系統接地方式：中性點非有效接地系統；

2.4大氣條件：大氣中無嚴重污穢。

使用方法和注意事項：

5.1本產品如用于計量分支線路的電度或用于考核線路損耗時，可將計量

箱安裝在電桿的支架上。

5.2用于計量電力變壓器高壓側電度時，可與變壓器安裝在同一個平臺上或安裝在

電桿上。

5.3新安裝運行中的計量箱發現相序相反時，會出現有功電度表仍然正轉，無功電

度表反轉的現象，造成電度表計量錯誤，應將計量箱高壓側任意兩根對換位置，計量箱

變?yōu)檎嘈蜻M(jìn)行，才能**計量箱準確計量。

5.4本產品用于二相一地的電力線路計量電度時，應將地相接在計量箱B相上，其余

二相按正相序連接，防止產生計量的附加誤差。

5.5產品吊運時必須使用油箱上的吊攀。

5.6組合互感器的二次接線端子b點和油箱上的接地螺栓應可靠接地，以免造成事故

6、維護和保管：

或補充新油。

6.2計量箱在使用前需要妥善地保管在倉庫內，倉庫的溫度為-25℃至＋40℃，相對

濕度不大于85％，通風良好，無腐蝕性氣體存在。

7、訂貨須知：

在訂購本型產品時，請?jiān)敿?xì)說明下列項。

7.1產品型號；

7.2額定電壓比；

7.3額定電流比；

7.4準確級；

7.5產品使用環境；

7.6單相計量或雙向計量

Jls-6 and 10 meter boxes are suitable for the electric energy measurement in the following situations:

A. Rural drainage and irrigation stations, township enterprises, processing plants, small and medium sized factories, mining areas, transportation and other enterprises

Electric energy measurement of high-voltage transmission lines temporarily set up for power supply stations in in**l units and forestry and infrastructure construction sites.

B. Measurement of power generation of small power stations or measurement of power transmission between the power grid of small power stations and the state in connection with the operation of the network.

2. Environmental conditions:

2.1 the altitude shall not exceed 1000m;

2.2 ambient temperature:

High + 40 ℃;

The average no more than 30 ℃;

Low - 25 ℃;

2.3 system grounding: neutral non-effective grounding system;

2.4 atmospheric conditions: there is no serious pollution in the atmosphere.

Usage and precautions:

5.1 this product can be measured if it is used to measure the power of branch lines or when it is used to assess the line loss

The box is mounted on the bracket of the pole.

5.2 when measuring the power transformer"s high voltage side power, it can be installed on the same platform or installed on the same platform as the transformer

On the pole.

5.3 when the meter box in the new installation and operation is found to have opposite phase sequence, the active power meter will still turn forward and reactive power will appear

When the meter is reversed, the meter is wrong, and any two of the high-voltage side of the meter box should be replaced

Change into positive phase sequence to ensure accurate measurement of the meter box.

5.4 when the product is used to measure the electrical degree of power lines in two phases and one place, the ground shall be connected to the B phase of the meter box, and the rest

The two phases are connected in a positive phase sequence to prevent additional measurement errors.

5.5 the product must be hoisted by the oil tank.

5.6 the secondary terminal b of the combined transformer and the grounding bolt on the fuel tank shall be reliably grounded to avoid accidents

6. Maintenance and custody:

Or new oil.

6.2 metering box before use to properly keep in the warehouse, the warehouse temperature is 25 ℃ to + 40 ℃, the relative

Humidity not more than 85%, good ventilation, non - corrosive gas presence.

7. Ordering instructions:

Please specify the following items when ordering this model.

7.1 product model;

7.2 rated voltage ratio;

7.3 rated current ratio;

7.4 accuracy level;

7.5 product use environment;

7.6 single-phase measurement or two-way measurement